ABB Module DSQC201 YB560103-AB ABB DSQC201 Robotics Axis Board Performance great

ABB Module DSQC201 YB560103-AB ABB DSQC201 Robotics Axis Board Performance great

Product Description:

The central unit to correctly access the inputs and outputs.A detailed description about "Addressing" can be found in the chapter "Addressing" for the central processing unit and couplers.The setting of the address must be done with the DIL switch located under the slide cover on the right side of the module
housing (see Fig. 5.4-3). When using central units 07 KR 91, 07 KT 9x as bus master, the following address allocations resultAs shown in the table, the module occupies 8 analog inputs and 8 analog outputs on the CS31 system bus.If the module is confiugured in operating mode "8 bits"only for inputs or only for outputs, only 8 analog inputs or 8 analog outputs are used on the CS31 system bus. In
this case, not occupied input or output addresses can be used by other modules.If the address DIL switch No. 8 is switched to ON, all channel numbers change by 08, i.e. address AW n,00 changes to AW n,08, etc. This applies for the address assignments for inputs and outputs in both operation
modes.

Related Product Recommendation:

Product's Character:

Normal operation After the supply voltage was switched on, the module initializes automatically. During initialization process all LEDs are switched on.If the CS31 system bus does not (yet) run, the red
error LED will light up. If an error occurs during the initialization process, the red error LED will also
light up. Diagnosis and displays The module 07 AC 91 offers the following diagnosis functions: Analog value is out of measuring range Storing this information and possibility for recall (kind of error and location of error) If an error occurs, the red LED lights up. The error message will be transmitted to the central unit or the coupler.

The use of the product: