DS200SIOCG1A VME Stand I / O Board

Product Specification

Product Details

The GE VersaModular Eurocard (VME) Stand I/O Board DS200SIOCG1A

features five wire terminals that can connect to a maximum of 33 signal

wires. It is also populated with one fuse and four 2-pin connectors. The

wire terminal blocks on the GE VME Stand I/O Board DS200SIOCG1A

are labeled TB-1, TB-2, TB-3, TB-4, and TB-5 on the board. The wires

carry signals that are transmitted by the board or are received by the board

during processing. The wires are held in place with screws that secure the

wires in the terminals. Each terminal also has an identifier printed on the

board.

When you replace the board you must first tag each wire connected to a

terminal with the ID assigned to the terminal to which it is attached. Then,

when all power is removed from the board, you can loosen the screws that

secure the wire in the terminal. Check to make sure the tag is attached to

the wire and that is has the right terminal ID written on it. Bend the signal

wires out of the way so you can remove the old board and install the

replacement board.

GE News

GE-led Consortium to Build Two High-Efficiency, Lower Emission HA Combined Cycle

Power Units at Dolna Odra Power Plant in Poland:

PGE’s Dolna Odra Plant will be equipped with two GE 9HA.01 gas turbines, two

steam turbines, two generators and two heat recovery steam generators to deliver

world-class efficiency and flexibility for the combined cycle power plant.

More Products

Contact Us